Pakistan Cables 4mm² Pure Copper Wire – 90m Coil (Heavy Duty House & Solar Wiring)
Rs.24,447.00
Description
Pakistan Cables 4mm² pure copper wire is a heavy‑duty general wiring cable for main house wiring, solar connections, ACs, pumps, geysers, and commercial loads. It uses 99.99% pure copper with flame‑retardant PVC insulation, manufactured to BS 6004 standards for 450/750V systems – ideal for Pakistani conditions in Karachi, Lahore, Islamabad and beyond.
Where 4mm Wire Is Best
-
Main wiring for ACs (up to 3 ton)
-
Solar DC wiring between panels, controllers and inverters (short runs)
-
Water pumps and motors up to 2–3 HP (depending on length)
-
Main lines from meter to distribution board
-
Heavy socket circuits (iron, heater, oven, etc.)
Technical Specifications
-
Conductor: 99.99% pure copper, high‑conductivity
-
Size / Cross‑section: 4mm² (approx. 11 AWG)
-
Type: Single‑core general wiring cable (stranded or solid depending on variant)
-
Voltage rating: 450/750V AC (suitable for 250/440V systems)
-
Insulation: FR PVC (flame retardant, 70 °C)
-
Coil length: 90 meters guaranteed
-
Ampacity (typical): 27–32A in conduit (check local code)
-
Colors: Red, Yellow, Blue, Black, Green/Yellow (earth)
-
Standards: BS 6004, IEC 60227, ISO certified
Load Capacity Guide (Real Use)
-
1 × 3‑ton split AC or 2 × 1.5‑ton ACs (short runs)
-
2–3 HP water pump (check distance and voltage drop)
-
Heavy socket circuits with iron, heater, microwave, oven
-
Solar strings up to 40A (short DC runs)
-
Main feed from meter to DB for small houses
Always confirm final cable size with a qualified electrician based on distance, breaker size, and load.
4mm vs 2.5mm vs 6mm – When to Choose 4mm
-
Compared to 2.5mm², 4mm² carries more current with lower voltage drop, ideal when load is high or cable run is long.
-
Compared to 6mm², 4mm² is more cost‑effective where loads are medium (one AC + sockets) rather than very heavy (multiple ACs, big pumps).
Use 4mm when:
-
Breaker is 25–32A
-
Cable length is moderate to long
-
You want extra safety margin on heating and voltage drop
Why Pakistan Cables 4mm Beats Generic Brands
-
99.99% pure copper, no CCA or mixed metals
-
True 90m coil – no short length scams
-
FR PVC insulation tested for heat and flame
-
Manufactured by Pakistan’s most trusted cable brand since 1953
-
Complies with BS 6004 / IEC for long‑term safety and performance
Installation Tips (Electrician‑Grade)
-
Use correct breaker size (typically 25A or 32A for 4mm, depending on installation and local code).
-
Pull cable in 20–25 mm PVC conduit to protect against moisture and mechanical damage.
-
Strip 12–15 mm insulation, ensure all strands are inside the terminal – no loose copper.
-
Tighten MCB / isolator terminals to recommended torque to avoid hotspots.
-
For solar use, keep DC runs as short as possible and avoid sharp bends.
Frequently Asked Questions
Q: Is this cable suitable for AC wiring?
Yes. 4mm² Pakistan Cables is commonly used for 1.5–3 ton split ACs and similar loads, depending on cable length and breaker size. Always confirm with an electrician.
Q: Can I use 4mm for solar panels and inverters?
Yes, 4mm² pure copper cable is widely used for solar DC wiring on small and medium residential systems, especially between combiner boxes and inverters. Check current and distance for final sizing.
Q: Is the coil exactly 90 meters?
Yes, Pakistan Cables coils are factory‑measured 90m, unlike cheaper brands that may be short.
Q: Is it solid or stranded?
Pakistan Cables offers single‑core 4mm general wiring typically in stranded construction for flexibility, and solid in some earthing variants. Check product label or our listing details.
Q: Can this replace 7/29 wire?
7/29 is roughly 2.5mm²; 4mm² is thicker and can handle higher current with less voltage drop, so it’s a good upgrade when loads are heavier or runs are longer.
Q: What colors should I choose?
Common practice in Pakistan: Red/Yellow/Blue for phases, Black for neutral, Green/Yellow for earth.
Q: Is it safe for outdoor use?
Yes, as long as it is installed in proper conduit or trunking and not exposed directly to sunlight or mechanical damage.